348 results (0,14941 seconds)

Show all filters

Brand

Show all

Merchant

Price (EUR)

Reset filter

Products
From
Shops

C-Tec AFP711 XFP Network Communications Card

C-Tec AFP711 XFP Network Communications Card

C-Tec AFP711 XFP Network Communications CardAn optional system expansion device for use with XFP 12 Loop 32 Zone fire panels. Allowsthe connection of up to eight XFP Repeaters or eight XFP Main panels any mix on an RS485 network. One AFP711 card required per networked Main XFP 12 Loop 32 Zone panel note that XFP510-16 and XFP510-32 repeaters include a network driver card as standard.The AFP711 is NOT compatible with XFP Single Loop 16 Zone panels which require a CFP761 card for networking.Key network protocol features when used for interconnecting XFP main panelsCan be used to connect up to 8 XFP main panels any mix over a two-wire RS485 network of up to 1KM in length.Each networked XFP can be programmed to accept Fires Faults and Control actions such as Silence Alarm Sounders and Control Panel Resets from other panels.Each XFP will accept Disablement commands for zones sounders and output sets from other panels.All panels monitored for network wiring faults.Fires and faults on remote panels are displayed on local panels including the point description.CEs can be programmed into local panels dependent on which remote panel is in alarm.The network supports the programming of site data into remote panels from a PC at a local panel.Time and date is common to all panels.All networked main panels require a network communication card.It is not possible to mix XFP main panels and XFP repeaters on the same network.Key network protocol features when used for connecting XFP repeatersCan be used to connect up to 8 XFP repeaters any mix to one XFP main panel.Up to 500m of cable may be fitted to an XFP two-wire repeater network.Each XFP repeater offers all the functions and controls of an XFP main panel.The XFP main panel must have a network communication card fitted.It is not possible to mix XFP main panels and XFP repeaters on the same network.

GBP 114.65
1

Carrier UVP-C60 60cm Ceiling Mount for UltraView PTZ Dome - Cable Management - 32 mm

Carrier UVP-C60 60cm Ceiling Mount for UltraView PTZ Dome - Cable Management - 32 mm

Carrier UVP-C60 60cm Ceiling Mount for UltraView PTZ Dome - Cable Management - 32 mmThe UVP-C60 is a ceiling mount bracket for all TruVision and UltraView PTZ cameras. It allows you to pendant mount PTZ cameras at 60 cm from the ceiling.The brackets cable management function allows for an efficient and aesthetically pleasing installation.Key FeaturesCeiling mountFits all TruVision PTZ camerasCable management60 cm length32mm diameter

GBP 110.20
1

Carrier UVP-C30 30cm Ceiling Mount for UltraView PTZ Dome - Cable Management - 32 mm

Carrier UVP-C30 30cm Ceiling Mount for UltraView PTZ Dome - Cable Management - 32 mm

Carrier UVP-C30 30cm Ceiling Mount for UltraView PTZ Dome - Cable Management - 32 mmThe UVP-C30 is a ceiling mount bracket for all TruVision and UltraView PTZ cameras. It allows you to pendant mount PTZ cameras at 30 cm from the ceiling.The brackets cable management function allows for an efficient and aesthetically pleasing installation.Key FeaturesCeiling mountFits all TruVision PTZ camerasCable management30 cm length32mm diameter

GBP 121.36
1

C-Tec CP414TV CAST-PRO Smoke Heat Multisensor cw Tone Sounder amp C-3-9.4 White VAD

C-Tec CP414TV CAST-PRO Smoke Heat Multisensor cw Tone Sounder amp C-3-9.4 White VAD

C-Tec CP414TV CAST-PRO Smoke Heat Multisensor cw ToneSounder C-3-9.4 White VADMultiple functionality in a single device smoke heatmultisensor fire detection plus a 92dbA tone Alarm sounder and a C-3-9.4 VAD detects real fires quickly reduces false alarms effectively and indicatestrue alarm conditions decisively.Key FeaturesCertified to EN54-3 5 7 17 23 29.Compatible with C-TECs ZFP touchscreen-controlled CASTprotocol addressable fire panel.MASC Miniature Advanced Smoke Detection Chamber andAFFIRM algorithms provide incredible tolerance to false alarms whilstenhancing the detection of real fire conditions.Drift compensation functionality.Onboard short circuit loop isolator.Includes two 8mm x 2mm ultra-bright red LED indicatingstrips.Multiple detection modes and different sensitivities fordifferent times of the day.13.2mA max. alarm current max vol VAD on.590uA typical quiescent current 40V DC.Compatible with C-TECs CA408 CAST base cwintegrated locking mechanism ID tag.

GBP 112.94
1

C-Tec NC802DEMSS MK4 Stainless Steel Call Point

C-Tec NC802DEMSS MK4 Stainless Steel Call Point

C-Tec NC802DEMSS MK4 Stainless Steel Call PointThe C-Tec NC802DEMSS is a Stainless-Steel Call Point which has been designed for use with the C-Tec 800 Series Call System. This call point features a magnetic reset facility.The C-Tec 800 Series Conventional Call System is a tried trusted and respected by users and installers alike the C-Tecs 800 Series Call System is ideal for use in all types of private commercial residential and public sector buildings. Incorporating two different disabled persons toilet alarm kits a wide range of indicator panels and an extensive array of system components it is without doubt one of the most versatile and reliable conventional call systems on the market.

GBP 128.05
1

Aritech ATS1238 PIRcam PEB Panel Expansion Board 868mhz Gen2 For 32 Wireless Zones 16 Wireless Keyfobs

Aritech ATS1238 PIRcam PEB Panel Expansion Board 868mhz Gen2 For 32 Wireless Zones 16 Wireless Keyfobs

Aritech ATS1238 PIRcam PEB Panel Expansion Board 868mhz Gen2 For 32 Wireless Zones 16 Wireless KeyfobsThe ATS1238 Advanced Wireless Data Gathering Panel DGPreceiver expands the Advisor Advanced panels input capability by upto 32 zones using Carrier Security wireless PIRCam and 868MHz Gen2 Wireless Sensors i.e. PIR Door contact etc. The ATS1238 istypically installed inside the large poly housing and connected to theMI bus interface of the Advisor Advanced panel.The ATS1238 features spatial diversity to minimize wireless signalnulls or dead spots and has a nominal open-air receiving range of400m. If dead spots need to be eliminated a 868MHz repeater may beused for the 868Gen2 devices only.Data Gathering PanelsData Gathering Panels DGPs are used to expand the number ofalarm inputs on the system and allow inputs and relays to beconnected at a location remote from the Advisor Advanced. DGPscommunicate via poll reply messages and send alarms to the controlpanel for processing. The DGPs collect information from detectorsdoor contacts and other similar devices. There are DGPs available forconventional devices wireless devices as well as for intelligentaddressable devices. A special DGP is also available for collecting theinformation from either four door or lift controllers.FunctionalityThe ATS1238 Wireless Data Gathering Panel DGP receiver expandsthe Advisor Advanced panels input capability by up to 32 zones usingCarrier FS Learn Mode 868MHz Wireless Transmitters and PIRCameras.Fob buttons may be programmed for users to arm and disarm or tocontrol relays for example to remotely open and close a garage dooras well as arm or disarm an office security system.PIR Cameras can be used to take pictures from any event in thesystem which can be reported to a monitoring station or end usersphone for means of verification.EN50131The ATS1238 meets prEN50131Grade 2 specifications for wirelesssystems like Detector supervision and local and remote attenuation of- 6dB for commissioning and maintenance.

GBP 157.52
1

C-Tec CP414TVR CAST-PRO Smoke Heat Multisensor cw Tone Sounder amp O-C-1.9-4 Red VAD

C-Tec CP414TVR CAST-PRO Smoke Heat Multisensor cw Tone Sounder amp O-C-1.9-4 Red VAD

C-Tec CP414TVR CAST-PRO Smoke Heat Multisensor cw ToneSounder O-C-1.9-4 Red VADMultiple functionality in a single device smoke heatmultisensor fire detection plus a 92dbA tone Alarm sounder and an O-C-1.9-4red VAD detects real fires quickly reduces false alarms effectively andindicates true alarm conditions decisively.Key FeaturesCertified to EN54-3 5 7 17 23 29.Compatible with C-TECs ZFP touchscreen-controlled CASTprotocol addressable fire panel.MASC Miniature Advanced Smoke Detection Chamber andAFFIRM algorithms provide incredible tolerance to false alarms whilstenhancing the detection of real fire conditions.Drift compensation functionality.Onboard short circuit loop isolator.Includes two 8mm x 2mm ultra-bright red LED indicatingstrips.Multiple detection modes and different sensitivities fordifferent times of the day.13.2mA max. alarm current max vol VAD on.590uA typical quiescent current 40V DC.Compatible with C-TECs CA408 CAST base cwintegrated locking mechanism ID tag.

GBP 133.36
1

C-Tec CP414VV CAST-PRO Smoke Heat Multisensor cw Voice Sounder amp C-3-9.4 White VAD

C-Tec CP414VV CAST-PRO Smoke Heat Multisensor cw Voice Sounder amp C-3-9.4 White VAD

C-Tec CP414VV CAST-PRO Smoke Heat Multisensor cw VoiceSounder C-3-9.4 White VADA multiple functionality in a single device smoke heat multisensor fire detection plus an 86dbA voice sounder and a C-3-9.4 VAD detects real fires quickly reduces false alarms effectively and indicatestrue alarm conditions decisively.Key FeaturesCertified to EN54-3 5 7 17 23 29.Compatible with C-TECs ZFP touchscreen-controlled CASTprotocol addressable fire panel.MASC Miniature Advanced Smoke Detection Chamber andAFFIRM algorithms provide incredible tolerance to false alarms whilstenhancing the detection of real fire conditions.Drift compensation functionality.Onboard short circuit loop isolator.Includes two 8mm x 2mm ultra-bright red LED indicatingstrips.Multiple detection modes and different sensitivities fordifferent times of the day.Six selectable voice messages with tones 2 evacuate 1alert 1 all clear 2 system test messages.24.9mA max. alarm current max vol VAD on.590uA typical quiescent current 40V DC.Compatible with C-TECs CA408 CAST base cwintegrated locking mechanism ID tag.

GBP 160.57
1

C-Tec NC805AS Air Switch

C-Tec NC805AS Air Switch

C-Tec NC805AS Air SwitchThe NC805AS is designed for use with C-TECsNC805P Pneumatic Pad. Applying pressure to the NC805P operates the airswitch which in turn triggers a Standard call when the 6.35mm jack plug on the NC805ASis connected to a compatible call points remote socket.Key FeaturesOperates at a minimum differential air pressure of 0.9 p.s.i pounds per square inch or 6220 Pa pascals 10 at 16CIP Rating IP20Ideal for patients who find it difficult to press buttons

GBP 106.18
1

Vimpex SG2E-SS-R-32 SmartGuard 2 - Environmental - Surface Mount - Red - 32mm Spacer - Sounder

Vimpex SG2E-SS-R-32 SmartGuard 2 - Environmental - Surface Mount - Red - 32mm Spacer - Sounder

Vimpex SG2E-SS-R-32 SmartGuard 2 - Environmental - Surface Mount - Red - 32mm Spacer - SounderThe SmartGuard 2 is larger than the standard sizedSmartGuard and is designed to be installed over German and US style callpoints and pull stations. SmartGuard 2 offers the same features andinstallation options as SmartGuard.Key FeaturesDesigned for ease of installation the SmartGuard can befitted in minutesAn optional battery powered 90dB alarm can be fittedincreasing the security and protection of the device it is coveringA break seal can also be fitted to increase the visibledeterrent against misuseDesigned to be installed over German and US style callpoints and pull stationsColour Red32mm spacerIncludes sounder

GBP 93.91
1

C-Tec CP414VVR CAST-PRO Smoke Heat Multisensor cw Voice Sounder amp O-C-1.9-4 Red VAD

C-Tec CP414VVR CAST-PRO Smoke Heat Multisensor cw Voice Sounder amp O-C-1.9-4 Red VAD

C-Tec CP414VVR CAST-PRO Smoke Heat Multisensor cw VoiceSounder O-C-1.9-4 Red VADA multiple functionality in a single device smoke heat multisensor fire detection plus an 86dbA voice sounder and an O-C-1.9-4red VAD detects real fires quickly reduces false alarms effectively andindicates true alarm conditions decisively.Key FeaturesCertified to EN54-3 5 7 17 23 29.Compatible with C-TECs ZFP touchscreen-controlled CASTprotocol addressable fire panel.MASC Miniature Advanced Smoke Detection Chamber andAFFIRM algorithms provide incredible tolerance to false alarms whilstenhancing the detection of real fire conditions.Drift compensation functionality.Onboard short circuit loop isolator.Includes two 8mm x 2mm ultra-bright red LED indicatingstrips.Multiple detection modes and different sensitivities fordifferent times of the day.Six selectable voice messages with tones 2 evacuate 1alert 1 all clear 2 system test messages.24.9mA max. alarm current max vol VAD on.590uA typical quiescent current 40V DC.Compatible with C-TECs CA408 CAST base cw integratedlocking mechanism ID tag.

GBP 169.64
1