15 results (0,14276 seconds)

Show all filters

Brand

Merchant

Price (EUR)

Show all

Reset filter

Products
From
Shops

SAS NET214 Pull Switch With Reassurance LED - 1k Resistor

SAS NET214 Pull Switch With Reassurance LED - 1k Resistor

SAS NET214 Pull Switch With Reassurance LED - 1k ResistorThese switches are commonly used in bathrooms and toilets. They are fitted with 2.5 metres of cord and have two triangular pulls fitted for ease of use. They incorporate a red reassurance light to indicate that a call has been made.Key FeaturesFitted with a pull cord 2.25 metres long2 triangles for ease of useSwitch Dimensions W86 x H31mmPull Cord Dimensions L2250mmBack box requirements Flush Besa circular conduit box M4 fixingWeight - Ceiling switch 64gMaterial ABS Nylon

GBP 19.44
1

SAS Caring Technology Touch-Wireless-CP Touch Wireless Call Point with Call Level No Reset

SAS Caring Technology Touch-Wireless-CP Touch Wireless Call Point with Call Level No Reset

SAS Caring Technology Touch-Wireless-CP Touch Wireless Call Point with CallLevel No ResetDesigned for challenging environments. The room unitmanufactured from injection molded Tritan Tx more resilient thanPolycarbonate is low profile and vandal resistant. The unit is touch buttonactuated and any of the above configuration of active buttons can be achieved.The patient touches the area denoted by the orange paddle to activate a patientcall. The hidden LED in the centre of the call point illuminates red when thebuttons are touched. A low battery warning will sound when the battery is low.Upon detection of a low battery a CALL signal is sent out this will not besent again until the battery has been changed. While the room units battery islow it will continue to flash its red LED every 15 seconds and sound its buzzerevery 2 minutes. Staff should be made aware of this. The buttons in the framestaff only can be used by the nurse to reset the call. Included 2x torx M3.5x 25mm security screws 3 x AAA batteries surface back box optionalThe wireless call points are a cost-effectiveapproach to add nurse call to an existing staff attack system. This helps keepdisruption to a minimum since no walls need to be chased and are easilyinstalled with an anti-ligature surface collar. The slave wireless call pointsyncs with a master IR receiver which is addressed to understand its location.

GBP 186.30
1

SAS RED2081 Single Alarm Infrared Unit

SAS RED2081 Single Alarm Infrared Unit

SAS RED2081 Single Alarm Infrared UnitThe original transmitters from SAS. The RED2081 alarm transmitter is battery operated and incorporates a red alarm button and a clothing clip with pull activation for emergency calls. It can be tested using our RED2501 test station.The RED2092 is a reset transmitter. It has a blue reset signal button and a clothing clip with pull activation for emergence calls.The RED208T is a test transmitter. It has a white button and is used by staff to periodically test the infra-red receivers. Activating the transmitter in the vicinity of a receiver causes its LED to flash proving that it is working correctly.

GBP 97.20
1

SAS RED2092 Single Reset Infrared Unit

SAS RED2092 Single Reset Infrared Unit

SAS RED2092 Single Reset Infrared UnitThe original transmitters from SAS. The RED2081 alarm transmitter is battery operated and incorporates a red alarm button and a clothing clip with pull activation for emergency calls. It can be tested using our RED2501 test station.The RED2092 is a reset transmitter. It has a blue reset signal button and a clothing clip with pull activation for emergency calls.The RED208T is a test transmitter. It has a white button and is used by staff to periodically test the infra-red receivers. Activating the transmitter in the vicinity of a receiver causes its LED to flash proving that it is working correctly.

GBP 97.20
1

SAS Caring Technology Touch-Wireless-CP-ATT Touch Wireless Call Point with Attack Level No Reset

SAS Caring Technology Touch-Wireless-CP-ATT Touch Wireless Call Point with Attack Level No Reset

SAS Caring Technology Touch-Wireless-CP-ATT Touch Wireless Call Point with Attack Level No ResetDesigned for challenging environments. The room unit manufactured from injection molded Tritan Tx more resilient than Polycarbonate is low profile and vandal resistant. The unit is touch button actuated and any of the above configuration of active buttons can be achieved. The patient touches the area denoted by the orange paddle to activate a patient call. The hidden LED in the centre of the call point illuminates red when the buttons are touched. A low battery warning will sound when the battery is low. Upon detection of a low battery a CALL signal is sent out this will not be sent again until the battery has been changed. While the room units battery is low it will continue to flash its red LED every 15 seconds and sound its buzzer every 2 minutes. Staff should be made aware of this. The buttons in the frame staff only can be used by the nurse to reset the call. Included 2x torx M3.5 x 25mm security screws 3 x AAA batteries surface back box optionalThe wireless call points are a cost effective approach to add nurse call to an existing staff attack system. This helps keep disruption to a minimum since no walls need to be chased and are easily installed with an anti-ligature surface collar. The slave wireless call point syncs with a master IR receiver which is addressed to understand its location.LED FunctionGreen Battery goodYellow Battery should be changedRed Change battery nowPlease note The image is for illustrative purposes only.

GBP 186.30
1

SAS Caring Technology Touch-Wireless-CP-RU Touch Wireless Call Point with Call Reset Crash And Alarm Levels

SAS Caring Technology Touch-Wireless-CP-RU Touch Wireless Call Point with Call Reset Crash And Alarm Levels

SAS Caring Technology Touch-Wireless-CP-RU Touch Wireless Call Point with Call Reset Crash And Alarm LevelsDesigned for challenging environments. The room unit manufactured from injection molded Tritan Tx more resilient than Polycarbonate is low profile and vandal resistant. The unit is touch button actuated and any of the above configuration of active buttons can be achieved. The patient touches the area denoted by the orange paddle to activate a patient call. The hidden LED in the centre of the call point illuminates red when the buttons are touched. A low battery warning will sound when the battery is low. Upon detection of a low battery a CALL signal is sent out this will not be sent again until the battery has been changed. While the room units battery is low it will continue to flash its red LED every 15 seconds and sound its buzzer every 2 minutes. Staff should be made aware of this. The buttons in the frame staff only can be used by the nurse to reset the call. Included 2x torx M3.5 x 25mm security screws 3 x AAA batteries surface back box optionalThe wireless call points are a cost effective approach to add nurse call to an existing staff attack system. This helps keep disruption to a minimum since no walls need to be chased and are easily installed with an anti-ligature surface collar. The slave wireless call point syncs with a master IR receiver which is addressed to understand its location.LED FunctionGreen Battery goodYellow Battery should be changedRed Change battery nowPlease note The image is for illustrative purposes only.

GBP 202.50
1

SAS Caring Technology Touch-Wireless-CP-R Touch Wireless Call Point with Call Reset Reset And Test Levels

SAS Caring Technology Touch-Wireless-CP-R Touch Wireless Call Point with Call Reset Reset And Test Levels

SAS Caring Technology Touch-Wireless-CP-R Touch Wireless Call Point with Call Reset Reset And Test LevelsDesigned for challenging environments. The room unit manufactured from injection molded Tritan Tx more resilient than Polycarbonate is low profile and vandal resistant. The unit is touch button actuated and any of the above configuration of active buttons can be achieved. The patient touches the area denoted by the orange paddle to activate a patient call. The hidden LED in the centre of the call point illuminates red when the buttons are touched. A low battery warning will sound when the battery is low. Upon detection of a low battery a CALL signal is sent out this will not be sent again until the battery has been changed. While the room units battery is low it will continue to flash its red LED every 15 seconds and sound its buzzer every 2 minutes. Staff should be made aware of this. The buttons in the frame staff only can be used by the nurse to reset the call. Included 2x torx M3.5 x 25mm security screws 3 x AAA batteries surface back box optionalThe wireless call points are a cost effective approach to add nurse call to an existing staff attack system. This helps keep disruption to a minimum since no walls need to be chased and are easily installed with an anti-ligature surface collar. The slave wireless call point syncs with a master IR receiver which is addressed to understand its location.LED FunctionGreen Battery goodYellow Battery should be changedRed Change battery nowPlease note The image is for illustrative purposes only.

GBP 186.30
1

SAS ReconRED208 Reconditioned RED208 Infrared Unit

SAS ReconRED208 Reconditioned RED208 Infrared Unit

SAS ReconRED208 Reconditioned RED208 Infrared UnitThe ReconRED208 is a Reconditioned RED208 Infrared Unit.Carried by staff in establishments where they may feel at risk of an attack or who might need to call for urgent assistance. An alarm button is used to unobtrusively activate an alarm call on the nearest infra-red sensor. Pulling the transmitter away from its clothing clip activates an attack call. The unit is battery operated and it is easily replaced by the user. IA button is provided to check the battery health indicated by an LED array on the transmitter furthermore the nearest infra-red sensors reassurance light will flash to confirm a healthy signal. This is a confidence inspiring feature for the user who can quickly test the transmitter and sensors function in an environment when dealing with a potentially serious situation. All transmitters have a serial number and the facility to personalise the label.The Red Alert system helps staff feel more secure knowing that in an emergency they can summon assistance at the touch of a button on their personal transmitter.

GBP 64.80
1

SAS RED2096 Curo Reset Unit

SAS RED2096 Curo Reset Unit

SAS RED2096 Curo Reset UnitThe RED2086 alarm transmitter is carried by staff in establishments where they may feel at risk of an attack or might need to call for urgent assistance. This is our latest design of infra-red transmitter and it is powered a rechargeable battery. A full charge will last for months rather than weeks and a quick 2 hours is all it takes to get it back to a fully charged state. The transmitter incorporates a red alarm button and a unique emergency call pull activation that keeps the transmitter attached to your person. A pair of side buttons is provided to give a double action switch. A green button is pressed to check the battery condition indicated by an LED furthermore the nearest infra-red receivers reassurance light will flash to confirm a healthy signal. This is a confidence inspiring feature for the user who can quickly test the transmitter and receivers function when dealing with a potentially serious situation. As further backup a bleep will be heard from the transmitter when a battery requires a quick charge.The RED2096 reset transmitter has the same features as the alarm transmitter but has a blue button that is used to cancel alarm calls at their origin. This important feature means that calls have to be dealt with by visiting the area of activation.

GBP 113.40
1

SAS RED2086 Curo Alarm Unit

SAS RED2086 Curo Alarm Unit

SAS RED2086 Curo Alarm UnitThe RED2086 alarm transmitter is carried by staff in establishments where they may feel at risk of an attack or might need to call for urgent assistance. This is our latest design of infra-red transmitter and it is powered a rechargeable battery.A full charge will last for months rather than weeks and a quick 2 hours is all it takes to get it back to a fully charged state.The transmitter incorporates a red alarm button and a unique emergency call pull activation that keeps the transmitter attached to your person.A pair of side buttons is provided to give a double action switch. A green button is pressed to check the battery condition indicated by an LED furthermore the nearest infra-red receivers reassurance light will flash to confirm a healthy signal.This is a confidence inspiring feature for the user who can quickly test the transmitter and receivers function when dealing with a potentially serious situation.As further backup a bleep will be heard from the transmitter when a battery requires a quick charge.The RED2096 reset transmitter has the same features as the alarm transmitter but has a blue button that is used to cancel alarm calls at their origin. This important feature means that calls have to be dealt with by visiting the area of activation.

GBP 113.40
1

SAS RED2086RF Radio Curo Alarm Unit

SAS RED2086RF Radio Curo Alarm Unit

SAS RED2086RF Radio Curo Alarm UnitThe RED2086RF is a Radio Curo Alarm Unit.The RED2086 alarm transmitter is carried by staff in establishments where they may feel at risk of an attack or might need to call for urgent assistance. This is our latest design of infra-red transmitter and it is powered a rechargeable battery.A full charge will last for months rather than weeks and a quick 2 hours is all it takes to get it back to a fully charged state.The transmitter incorporates a red alarm button and a unique emergency call pull activation that keeps the transmitter attached to your person.A pair of side buttons is provided to give a double action switch. A green button is pressed to check the battery condition indicated by an LED furthermore the nearest infra-red receivers reassurance light will flash to confirm a healthy signal.This is a confidence inspiring feature for the user who can quickly test the transmitter and receivers function when dealing with a potentially serious situation.As further backup a bleep will be heard from the transmitter when a battery requires a quick charge.The RED2096 reset transmitter has the same features as the alarm transmitter but has a blue button that is used to cancel alarm calls at their origin. This important feature means that calls must be dealt with by visiting the area of activation.

GBP 153.90
1