3 results (0,15334 seconds)

Show all filters

Brand

Merchant

Price (EUR)

Reset filter

Products
From
Shops

Haes TPCA01-E4MAR Marine Approved TPC Esento 4 Zone Main Processor Zone PCB

Haes TPCA01-E4MAR Marine Approved TPC Esento 4 Zone Main Processor Zone PCB

Haes TPCA01-E4MAR Marine Approved TPC Esento 4 Zone Main Processor Zone PCBThe TPCA01-E4MAR is a Master PCB for Esento Marine 4-zone panels. Zones 1-4 are Fire alarm zone circuits. Conventionally wired detection circuit. Maximum 32 detectors per zone.Key Features4-Zone Master PCB boardPower supply voltage control line for temperature compensation control28VDC supply input diode protected for reversal and independent short circuit maximum current 3A28VDC supply output for fire alarm accessory relays etc maximum continuous use 400mA fused at 500mA resettable fuseFire relay contact clean CO maximum 3A at 30VDC unfusedMaintained fault relay contact clean CO maximum 3A at 30VDC unfused

GBP 209.56
1

Haes TPCA11-16 XL32 16 Zone Main Processor amp Circuit Board

Haes TPCA11-16 XL32 16 Zone Main Processor amp Circuit Board

Haes TPCA11-16 XL32 16 Zone Main Processor Circuit BoardA 16-Zone Master PCB for Esento Evoque panels.Key FeaturesCompatible with Esento Evoque panelsMaster PCB board0.5mm2 to 2.5mm2 solid or stranded wirePower supply data control lines RS232 data28VDC supply input diode protected for reversal and independent short circuit maximum current 5A28VDC supply output for fire alarm accessory relays etcFire relay contactMaintained fault relay contactFire alarm zone circuits

GBP 377.92
1

Haes Comms Card for Repeater amp Network Connections TPCA05

Haes Comms Card for Repeater amp Network Connections TPCA05

Haes Comms Card for Repeater Network Connections TPCA05The Haes comms card TPCA05 allows up to eight XLEN or XL32 control panels to be networked. Any combination of panel can be used from a 2 zone to a 32 zone and in any order to provide up to 256 conventional or Twin Wire zones. The card simply plugs in on top of the main circuit board in the control panel. In addition to the eight control panels up to eight repeater panels or remote display units can also be added to the network. The remote display units are supplied with a 4 x 40 character backlit LCD and will display all system fires and faults as well as controlling Silence Reset and other functions for the entire network.The networking has been designed to be wired in a fault tolerant fail safe loop configuration from comms A to B and back to the main panel again. If replacing an older system where the existing cabling cannot be configured in a loop as above it is possible to re-programme the master panel back to legacy RS485 circuit comms monitoring. This then allows any topology of comms cabling to be utilised. The cards are also provided with six programmable switch negative outputs which can be utilised for any local switching requirements.

GBP 126.86
1