2 results (0,12736 seconds)

Show all filters

Brand

Merchant

Price (EUR)

Reset filter

Products
From
Shops

Elmdene 24Vdc 5A 0.8A Switch Mode PSU EN54 Approved 2 x 17Ah Batteries

Elmdene 24Vdc 5A 0.8A Switch Mode PSU EN54 Approved 2 x 17Ah Batteries

Elmdene 24Vdc 5A 0.8A Switch Mode PSU EN54 Approved 2 x 17Ah BatteriesThe STX2405 is an EN54-4 approved power supply ideal for use in Fire and Smoke and ventilation control Systems. Its regulated 27.6V dc output will supply up to 5 Amps continuous into the load in addition to providing up to 850mA for charging the standby batteries up to 17Ah. The power supply output features electronic short circuit protection under both mains and standby battery operation. Maximum battery life is assured through continuous active battery monitoring and the use of a two stage charger comprising bulk and temperature compensated final float phase depending upon battery condition.Once fully charged the product operates in Eco power saving mode whereby it will check and top up battery charge every 24 hours but will not waste energy by continuously attempting to charge a fully charged battery. This also extends the operating life of the batteries. Deep discharge protection prevents premature battery failure when operating from standby for extended periods.Key FeaturesCertified by UL to EN54-41997 A1 2002 A2 2006.Up to 5A current to load at 27.6V dc nominal regulated output.Charging capability to support 7 or 17Ah batteries.Electronic overload protection shuts down output until overload or short circuit is removed.Battery Monitor detects battery missing low battery short-circuit or reverse connection.Battery charging circuit is energised only when a battery is correctly connected and the battery voltage is greater than 14 V.No loss of output during automatic connection of battery to load on loss of mains.Deep discharge protection disconnects battery from load when battery voltage falls below 21 V.Diagnostic indicator LED Orange Internal.Fault indicator LED Yellow flashes on detection of output fault battery fault charger fault and mains failure.Mains indicator LED Green showing mains present Indicators check at start-up.Optional RS232 serial interface for fault reporting and diagnostics.Suitable to fit batteries up to 2 x 17AhE Box Power Supply 420h x 400w x 80d mmHinged LidPlease note The image is for illustrative purposes only. Pleasecontact usfor further information.

GBP 188.21
1

Elmdene 24Vdc 8A 1.6A Switch Mode PSU EN54 Approved 2 x 38Ah Batteries

Elmdene 24Vdc 8A 1.6A Switch Mode PSU EN54 Approved 2 x 38Ah Batteries

Elmdene 24Vdc 8A 1.6A Switch Mode PSU EN54 Approved 2 x 38Ah BatteriesThe STX2410 is an EN54-4 approved power supply ideal for use in Fire control Systems. Its regulated 27.6V dc output will supply a total of 10 Amps continuous into the load whilst also enabling battery charging. 7.2 Amps Load with 65Ah batteries 10 Amps with 18Ah batteries 8A with 38Ah Batteries.The power supply output features electronic short circuit protection under both mains and standby battery operation. Maximum battery life is assured through continuous active battery monitoring and the use of a three stage charger comprising bulk absorb and temperature compensated final float phase depending upon battery condition.Once fully charged the product operates in Eco power saving mode whereby it will check and top up battery charge every 2 hours but will not waste energy by continuously attempting to charge a fully charged battery. This also extends the operating life of the battery. Deep discharge protection prevents premature battery failure when operating from standby for extended periods.Key FeaturesCertified by UL to EN54-41997 A1 2002 A2 2006.Up to 10 A current to load at 27.6V dc nominal regulated output.Charging capability to support 18 38 or 65Ah batteries with intelligent load enhancement.Electronic overload protection shuts down output until overload or short circuit is removed.Battery Monitor detects battery missing low battery short-circuit or reverse connection.Battery charging circuit is energised only when a battery is correctly connected and the battery voltage is greater than 14 V.No loss of output during automatic connection of battery to load on loss of mains.Deep discharge protection disconnects battery from load when battery voltage falls to 21 V.Fault indicator LED Yellow flashes on detection of output fault battery fault charger fault and mains failure.Mains indicator LED Green showing mains present.RS232 serial interface for fault reporting and diagnostics interface to OEM equipment.Suitable to fit batteries up to 2 x 38AhH Box Power Supply - 420h x 420w x 180dHinged LidPlease note The image is for illustrative purposes only. Pleasecontact usfor further information.

GBP 377.77
1