5 results (0,17202 seconds)

Show all filters

Brand

Merchant

Price (EUR)

Reset filter

Products
From
Shops

Carrier 5150-W 2-Wire On-The-Glass Piezo Sensor With 30 cm Wire Leads NC Alarm Output

Carrier 5150-W 2-Wire On-The-Glass Piezo Sensor With 30 cm Wire Leads NC Alarm Output

Carrier 5150-W 2-Wire On-The-Glass Piezo Sensor With 30 cm Wire Leads NC Alarm OutputThe Sentrol 5150 series glass break detector has been designed using the latest electronic techniques. This enables the detector to contain all the necessary circuitry for excellent detection whilst filtering out and rejecting all unwanted signals that would normally result in a nuisance alarms e.g. ultra-sound radio frequency interference etc. The 5150 series will provide a 3 m radius of protection. Suitable for use on standard window glass plate wired tempered and laminated glass.Due to the design of the product the detector may be fitted as close as 2.5 cm from the window frame and still provide a full 3 m radius. The 5150 series detectors are passive sensors therefore any number of detectors may be installed on the same windowpane without the risk of interaction. The detectors use a fail-safe normally closed open to alarm relay contact enabling compatibility with any standard burglar alarm control equipment.The output from the relay contact should be connected via the alarm 24-hour tamper loop in order to provide early signalling at the control whether the alarm is switched on or off. The opening of the normally closed relay contact signals the alarm.Easily installs with pre-cut specially formulated 3M adhesive tape.Key Features3 m radius of coverage measured from the sensorProtects all glass types up to a standard thickness of 6.4 mm includingplate wired tempered and laminated glassIdeal for 24-hours loop protectionTwo wire sensor drawing no power from the loopCompatible with most wireless transmitters

GBP 12.82
1

Carrier 5150-M 2-Wire On-The-Glass Piezo Sensor With 30 cm Wire Leads NC Alarm Output

Carrier 5150-M 2-Wire On-The-Glass Piezo Sensor With 30 cm Wire Leads NC Alarm Output

Carrier 5150-M 2-Wire On-The-Glass Piezo Sensor With 30 cm Wire Leads NC Alarm OutputThe Sentrol 5150 series glass break detector has been designed using the latest electronic techniques. This enables the detector to contain all the necessary circuitry for excellent detection whilst filtering out and rejecting all unwanted signals that would normally result in a nuisance alarms e.g. ultra-sound radio frequency interference etc. The 5150 series will provide a 3 m radius of protection. Suitable for use on standard window glass plate wired tempered and laminated glass.Due to the design of the product the detector may be fitted as close as 2.5 cm from the window frame and still provide a full 3 m radius. The 5150 series detectors are passive sensors therefore any number of detectors may be installed on the same windowpane without the risk of interaction. The detectors use a fail-safe normally closed open to alarm relay contact enabling compatibility with any standard burglar alarm control equipment.The output from the relay contact should be connected via the alarm 24-hour tamper loop in order to provide early signalling at the control whether the alarm is switched on or off. The opening of the normally closed relay contact signals the alarm.Easily installs with pre-cut specially formulated 3M adhesive tape.Key Features3 m radius of coverage measured from the sensorProtects all glass types up to a standard thickness of 6.4 mm includingplate wired tempered and laminated glassIdeal for 24-hours loop protectionTwo wire sensor drawing no power from the loopCompatible with most wireless transmitters

GBP 13.24
1

Carrier NS3562-8P-2S-V2 Industrial 8-Port 101001000T 802.3AT POE 2-Port 1001000X SFP Wall Mount Managed Switch -40- 75C

Carrier NS3562-8P-2S-V2 Industrial 8-Port 101001000T 802.3AT POE 2-Port 1001000X SFP Wall Mount Managed Switch -40- 75C

Carrier NS3562-8P-2S-V2 Industrial 8-Port 101001000T 802.3AT POE 2-Port 1001000X SFP Wall Mount Managed Switch -40- 75CThe IFS NS3562-8P-2S-V2 is an Industrial Gigabit PoE Managed flat form factor Switch equipped with eight 101001000Mbps RJ45 ports with PoE 30w capabilities and two 1001000Mbps SFP fibre uplink ports. These are fully managed Layer 2 switches providing a robust industrial hardened design that provides for rapid operational recovery in the event of a network or power system failure.The IFS Industrial Gigabit Managed Switch Series supports advanced features including IEEE 802.1Q VLAN GVRP port link aggregation QoS broadcast storm control and MAC address filtering. The series also includes IGMP snooping and querying multicasting for media operations and bandwidth utilization to fit a variety of applications.Ideal for use in implementing highly fault-tolerant ring and mesh network architectures these switches are well suited for harsh environments such as industrial security factory automation and intelligent transportation systems ITS.With an IP-30 rated enclosure IFS Industrial Gigabit Managed Switches provide a high level of immunity against electromagnetic EMI and radio-frequency RFI interference typically found in industrial environments. This series of switches comply with IEC60068-2-xx standards for free-fall shock and vibration and operate in -40 C to 75 C temperatures found in difficult environments such as plant floors or in curbside traffic control cabinets.Key FeaturesFlat wall mount form factor8-port 101001000Base-T with PoE2-ports SFP fibre 1001000Base-XHigh-performance Switch ArchitectureUp to 20Gbps non-blocking switch fabric9K bytes Jumbo frame support8K MAC address table automatic source address learning and agingIGMP v1v2V3 Snooping up to 255 multicast Groups with IGMPQuerier mode support and MLD v1v2 Snooping up to 255 multicastGroups with MLD Querier mode supportVLAN Support - up to 255 VLANsQuality of Service QoS 802.1p priority 802.1Q VLAN tag DSCPTOS field in IP PacketMAC Filtering and Source IPMAC address port-bindingComplies with IEEE 802.3af IEEE 802.3at Power over Ethernet EndSpan PSE and up to 8 IEEE 802.3af 802.3at devices poweredIP30 metal enclosure DIN Rail and Wall Mount Design complete with magnetic mounting kitWide operating temperature range of -40C 75C

GBP 820.68
1

Carrier NS3552-8P-2S-V2 8-port Gigabit PoE Industrial Managed Switch

Carrier NS3552-8P-2S-V2 8-port Gigabit PoE Industrial Managed Switch

Carrier NS3552-8P-2S-V2 8-port Gigabit PoE Industrial Managed SwitchThe IFS NS3552-8P-2S-V2 is an Industrial Gigabit PoE Managed Switch equipped with eight 101001000Mbps RJ45 ports with PoE 30w capabilities and two 1001000Mbps SFP fibre uplink ports. These are fully managed Layer 2 switches providing a robust industrial hardened design that provides for rapid operational recovery in the event of a network or power system failure.The NS3552-8P-2S-V2 simplifies management of your IP video system by providing integration into TruVision Navigator 8.0 and above.The NS3552-8P-2S-V2 can provide information to TruVision Navigator such as ONVIF lables of cameras bandwidth usage per port and POE power control making installation and management IP Video systems simpler and effortless.With an IP-30 rated enclosure IFS Industrial Gigabit Managed Switches provide a high level of immunity against electromagnetic EMI and radio-frequency RFI interference typically found in industrial environments. This series of switches comply with IEC60068-2-xx standards for free-fall shock and vibration and operate in -40 C to 75 C temperatures found in difficult environments such as plant floors or in curbside traffic control cabinets.These switches not only incorporate the industry standard Rapid Spanning Tree Protocol IEEE 802.1w RSTP but also an advanced Industrial Fail-Safe IFS technology accommodating multiple redundant ring topologies and improved network recovery time of less than 20ms. The switches incorporate a redundant power supply system to further enhance network reliability and uptime. Ideal for use in implementing highly fault-tolerant ring and mesh network architectures these switches are well suited for harsh environments such as industrial security factory automation and intelligent transportation systems ITS.Key Features8-port 101001000Base-T with PoE2-ports SFP fibre 1001000Base-XFull support in TruVision Navigator 8 and above.High-performance Switch ArchitectureUp to 20Gbps non-blocking switch fabric9K bytes Jumbo frame support8K MAC address table automatic source address learning and ageingIGMP v1v2V3 Snooping up to 255 multicast Groups with IGMPQuerier mode support and MLD v1v2 Snooping up to 255 multicast Groups with MLD Querier mode supportVLAN Support - up to 255 VLANs groups out of 4094 VLAN IDs MVR Multicast VLAN Registration Voice VLAN MAC-Based VLAN ProtocolBased VLANQuality of Service QoS 802.1p priority 802.1Q VLAN tag DSCPTOS field in IP PacketIEEE 802.3ad LACP Static Trunk Supports 5 groups of 8-Port trunk supportAdvanced SecurityMAC Filtering and Source IPMAC address port-bindingComplies with IEEE 802.3af IEEE 802.3at Power over Ethernet End - Span PSE and up to 8 IEEE 802.3af 802.3at devices poweredCircuit protection prevent power interference between portsRobust Hardened DesignIP30 metal enclosure DIN Rail and Wall Mount DesignWide operating temperature range of -40C 75C

GBP 937.42
1

Carrier NS3550-8T-2S-V2 8-port 2-SFP Industrial Gigabit Managed Switch

Carrier NS3550-8T-2S-V2 8-port 2-SFP Industrial Gigabit Managed Switch

Carrier NS3550-8T-2S-V2 8-port 2-SFP Industrial Gigabit Managed SwitchThe IFS NS3550-8T-2S-V2 is an Industrial Gigabit Managed Switch equipped with eight 101001000Mbps RJ45 ports and two 1001000Mbps SFP fibre uplink ports. These are fully managed Layer 2 switches providing a robust industrial hardened design that provides for rapid operational recovery in the event of a network or power system failure.The IFS Industrial Gigabit Managed Switch Series supports advanced features including IEEE 802.1Q VLAN GVRP port link aggregation QoS broadcast storm control and MAC address filtering. The series also includes IGMP snooping and querying multicasting for media operations and bandwidth utilization to fit a variety of applications. Via aggregation of supporting ports the series allows the operation of highspeed trunk operation combining multiple ports. A maximum of four ports can be assigned for four trunk groups and support fail-over as well. Additionally its standards-compliant implementation ensures interoperability with equipment from other vendors.These switches not only incorporate the industry standard Rapid Spanning Tree Protocol IEEE 802.1w RSTP but also an advanced Industrial Fail-Safe IFS technology accommodating multiple redundant ring topologies and improved network recovery time of less than 20ms. The switches incorporate a redundant power supply system to further enhance network reliability and uptime. Ideal for use in implementing highly fault-tolerant ring and mesh network architectures these switches are well suited for harsh environments such as industrial security factory automation and intelligent transportation systems ITS.With an IP-30 rated enclosure IFS Industrial Gigabit Managed Switches provide a high level of immunity against electromagnetic EMI and radio-frequency RFI interference typically found in industrial environments. This series of switches comply with IEC60068-2-xx standards for free-fall shock and vibration and operate in -40 C to 75 C temperatures found in difficult environments such as plant floors or in curbside traffic control cabinets.Key Features8-port 101001000Base-T2-ports SFP fibre 1001000Base-XRS-232 DB9 console interface for basic switch management and setupHigh-performance Switch ArchitectureUp to 20Gbps non-blocking switch fabric9K bytes Jumbo frame support8K MAC address table automatic source address learning and ageingIGMP v1v2V3 Snooping up to 255 multicast Groups with IGMPQuerier mode support and MLD v1v2 Snooping up to 255 multicast Groups with MLD Querier mode supportVLAN Support - up to 255 VLANs groups out of 4094 VLAN IDs MVR Multicast VLAN Registration Voice VLAN MAC-Based VLAN Protocol Based VLANQuality of Service QoS 802.1p priority 802.1Q VLAN tag DSCPTOS field in IP PacketIEEE 802.3ad LACP Static Trunk Supports 5 groups of 8-Port trunk supportAdvanced SecurityMAC Filtering and Source IPMAC address port-bindingCircuit protection prevent power interference between portsRobust Hardened DesignIP30 metal enclosure DIN Rail and Wall Mount DesignWide operating temperature range of -40C 75C

GBP 542.74
1