52 results (0,13721 seconds)

Brand

Merchant

Price (EUR)

Reset filter

Products
From
Shops

SmartCell SC-32-0210-0001-99 SmartCell SounderWall VAD - White Body - Red Flash

SmartCell SC-32-0110-0001-99 SmartCell SounderWall VAD - Red Body - Red Flash

Carrier ATS1204E 8-32 Zones DGP Input Expander 3A Power Supply Large Metal Housing EN Grade 3 Class II

SmartCell SC-32-0220-0001-99 White Sounder and Wall Beacon VAD White Flash

SmartCell SC-32-0120-0001-99 Red Sounder and Wall Beacon VAD White Flash

Carrier UVP-C60 60cm Ceiling Mount for UltraView PTZ Dome - Cable Management - 32 mm

Carrier UVP-C30 30cm Ceiling Mount for UltraView PTZ Dome - Cable Management - 32 mm

Carrier ATS1201E 8-32 Zones DGP Input Expander 3A Power Supply Medium Metal Housing EN Grade 3 Class II

Carrier ATS1201E 8-32 Zones DGP Input Expander 3A Power Supply Medium Metal Housing EN Grade 3 Class II

Carrier ATS1201E 8-32 Zones DGP Input Expander 3A Power Supply Medium Metal Housing EN Grade 3 Class IIThe ATS1201ATS1203ATS1204 DGPs offer 8 standard inputs 8 Open Collectors OC outputs and a siren driver. The DGP can be expanded to a total of 32 inputs and 32 outputs. It has a built-in 3 A switched mode power supply.Data Gathering PanelsData Gathering Panels DGPs are used to expand the number of alarm inputs in an ATS MASTER ATS Classic system. DGPs allow inputs and outputs relays to be connected at a location remote from an ATS Classic panel. DGPs communicate via poll reply messages. Detectors door contacts and other detection devices are connected to DGPs that report any change of state to the control panel for processing. Available DGPs include support for conventional devices wireless devices as well as intelligent addressable devices. A special DGP available supports expansion of four intelligent doors or lifts.System databus connectionThe system databus is used to connect Data Gathering Panels as well as keypads and readers RASs to the ATS classic control panel. Remote devices can be up to 1.5 km from an ATS control panels when using the preferred wiring and cable types. Arming stations and Data Gathering Panels have to be connected via a 2 pair twisted and shielded data cable to the system databus connection to achieve this. WCAT 52 is recommended. Daisy chain is the preferred wiring method. The shield of the data cable should be connected to earth at the ATS control panel and should be left disconnected at any other end.

GBP 287.26
1

Carrier C-9602LW-NG Conventional Natural Gas Detector - 220VAC cw Local Buzzer Alarm and Relay

SmartCell SC-11-1201-0001-99 Wireless Control Panel 230VAC

SmartCell SC-11-2201-0001-99 Wireless Control Panel 24V

Carrier 5150-M 2-Wire On-The-Glass Piezo Sensor With 30 cm Wire Leads NC Alarm Output

Carrier 5150-M 2-Wire On-The-Glass Piezo Sensor With 30 cm Wire Leads NC Alarm Output

Carrier 5150-M 2-Wire On-The-Glass Piezo Sensor With 30 cm Wire Leads NC Alarm OutputThe Sentrol 5150 series glass break detector has been designed using the latest electronic techniques. This enables the detector to contain all the necessary circuitry for excellent detection whilst filtering out and rejecting all unwanted signals that would normally result in a nuisance alarms e.g. ultra-sound radio frequency interference etc. The 5150 series will provide a 3 m radius of protection. Suitable for use on standard window glass plate wired tempered and laminated glass.Due to the design of the product the detector may be fitted as close as 2.5 cm from the window frame and still provide a full 3 m radius. The 5150 series detectors are passive sensors therefore any number of detectors may be installed on the same windowpane without the risk of interaction. The detectors use a fail-safe normally closed open to alarm relay contact enabling compatibility with any standard burglar alarm control equipment.The output from the relay contact should be connected via the alarm 24-hour tamper loop in order to provide early signalling at the control whether the alarm is switched on or off. The opening of the normally closed relay contact signals the alarm.Easily installs with pre-cut specially formulated 3M adhesive tape.Key Features3 m radius of coverage measured from the sensorProtects all glass types up to a standard thickness of 6.4 mm includingplate wired tempered and laminated glassIdeal for 24-hours loop protectionTwo wire sensor drawing no power from the loopCompatible with most wireless transmitters

GBP 13.24
1

SmartCell SC-31-0100-0001-99 SC Sounder Red

SmartCell SC-31-0200-0001-99 SC Sounder White

SmartCell SC-33-0110-0001-99 SmartCell Sounder Ceiling VAD - Red Body - Red Flash

SmartCell SC-33-0220-0001-99 White Sounder and Ceiling Beacon White Flash

SmartCell SC-22-0200-0001-99 Dual SmokeHeat Detector Sounder

SmartCell SC-33-0120-0001-99 Red Sounder and Ceiling Beacon White Flash

SmartCell SC-23-0220-0001-99 Dual SmokeHeat Detector Sounder VAD White Flash

SmartCell SC-23-0210-0001-99 SmartCell SmokeHeat Combined Sounder-VAD - Red Flash