19 results (0,13945 seconds)

Brand

Merchant

Price (EUR)

Reset filter

Products
From
Shops

C-Tec ZFP1CA ZFP 1 Loop Panel 5A CAST

C-Tec ZFP2CA ZFP 2 Loop Panel 5A Cast

C-Tec ZFP120CA ZFP 1 Loop Panel 5A 20LED CAST

C-Tec ZFP220CA ZFP 2 Loop 5A 20LED CAST

C-Tec ZFP240CA ZFP 2 Loop Panel 5A 40LED CAST

C-Tec ZFP140CA ZFP 1 Loop Panel 5A 40LED CAST

C-Tec ZFP240PCA ZFP 2 Loop Panel 5A 40LED CAST cw Printer

C-Tec ZFP220PCA ZFP 2 Loop Panel 5A 20LED CAST cw Printer

C-Tec ZFP140PCA ZFP 1 Loop Panel 5A 40LED CAST cw Printer

C-Tec ZFP120PCA ZFP 1 Loop Panel 5A 20LED CAST cw Printer

C-Tec ECU-224 SigTEL 224 Line Desk Controller

Apollo 29600-799 Talentum Test Torch

Howler SA02M Radio Frequency RF Site Alarm Alert - Master Unit

Howler SA02M Radio Frequency RF Site Alarm Alert - Master Unit

Howler SA02M Radio Frequency RF Site Alarm Alert - Master UnitDo you suffer from an aversion to wires Are you hampered by budget constraints The twin of the popular Site Alert is this neat radio-link buddy he could be the answer to your problems.The Site Alert RF comes with a host of important features and boasts an open air range of approximately 1km. Each system can have up to 30 subsidiary units connected to a Master unit. And with 8 different channels you have plenty of scope.The whole family are famous for their silent chat. Uniquely the system includes a silent automatic disconnection warning meaning that should a unit become disconnected the Master unit can immediately identify when one of his buddies is in trouble. This enables you to deal with the situation quickly and easily.The distinctive weather-proof design is suitable for indoor and outdoor locations. They are solely powered by off-the shelf alkaline batteries so on-going maintenance is easy and economical.Key FeaturesVisual Warning - High intensity LED red flashing beacon fitted as standard Ideal for noisy areas.Noisy - 100dB at 1 metre.Weather Proof - Push onpush off switch operation.Battery Powered - Alkaline cheap and easy to replace.Battery Test - Built-in low battery warning.Wireless Linking - Up to 30 units can be linked no trailing wires.Flexibility - Open air range of approx. 1km and 8 channels ideal for multiple building projects.No Control Panel Required - Simple installation and setup very easy to use.Continuous Fault Monitoring - LED illuminates if any unit becomes disconnected.

GBP 516.25
1

C-Tec ZFP2MCA ZFP 2 Loop Panel 5A Cast - Medium Cabinet

C-Tec ZFP2MCA ZFP 2 Loop Panel 5A Cast - Medium Cabinet

C-Tec ZFP2MCA ZFP 2 Loop Panel 5A Cast - Medium CabinetA feature-rich touchscreen-controlled addressable fire panelwith C-Tec CAST compatible loop drivers.Created with the input of some of the worlds leading fire alarm and life safety experts the ZFP is the powerful touchscreen controlled fire alarm panel that everyones been waiting for.Designed and built in the UK the panel can be configured to suit any application. From small one out all out systems to large multi-loop networked systems with sophisticated cause and effects the ZFP can handle them all with ease.Simply tap the option you require and away you go. Whether youre the responsible person on site the installer the commissioning engineer or the emergency services you can access the information you require quickly and easily - all at the touch of a virtual button.Creating a sophisticated fire alarm system for an airport hospital university tower block hotel football stadium or other large building is just a few steps up from establishing a simple one out all out system for a small factory unit.All this and full compliance with EN54 parts 2 and 4 means that the ZFP is rapidly becoming the fire panel of choice for the fire industry worldwide.Key FeaturesThird-party certified to EN54 parts 2 4 and 13Multiple off-the-shelf variants or build your own panelusing our ZFP selection chartsRapid loop learn flexible cause effects and powerfulsystem diagnosticsHi-integrity fault-tolerant RS485 networking option allowsup to 128 network nodes 64 main panels and 64 Compact ControllersOptional A-Bus expansion PCBs paging and graphicinterface facilitiesENVISION Enabled fullly compatible with C-TECs new Cloudbased data managementremote access softwareIntuitive PC programming toolsMedium cabinet

GBP 1640.72
1

Scope TLINK12V Telemetry System for One-way Link DL3-05-12V amp RX10SDC

Scope TLINK12V Telemetry System for One-way Link DL3-05-12V amp RX10SDC

Scope TLINK12V Telemetry System for One-way Link DL3-05-12V RX10SDCT-Link takes a 5-zone DigiLink transmitter and combines it with a RX10 receiver and two aerials to produce an off the shelf one-way radio link between fire or intruder panels. The transmitter has five input zones which can be triggered by volts-free opening or closing contacts or can be configured to accept voltage applied or voltage removed.The system is supplied pre-configured to operate change-of-state so a closing contact at the transmitter sends a signal to the receiver to activate the corresponding zone output relay. When the transmitter input is de-activated the relay is deactivated so the output actually follows the input. A programming kit is available if you need to reconfigure the system. Additional transmitters and receivers can be added when needed.This can simply be achieved by installing Digilink transmitters and receivers adjacent to the fire or security panels where their relay contacts can be hard wired into the output inputs of the panel in order to provide wireless alarm signals between buildings. For roaming fire marshals and security personnel the serial output of the receiver can be connected to the Scope Connexions Range of paging transmitters in order to send pre-programmed text messages to pocket worn pagers.It is also possible to connect the printer output of analogue addressable panel to a serial port of the Connexions transmitter in order to transmit real time panel messages to the pagers thus saving valuable time by not having to view the message at the panel. The same format could also be deployed for access control plant monitoring lone worker and care home applications where staff has to be made aware of situations arising from automated or manual inputs.

GBP 917.75
1

Scope TLINKLT Telemetry System for One-way Link DL3-05-12V amp RX10LT

Scope TLINKLT Telemetry System for One-way Link DL3-05-12V amp RX10LT

Scope TLINKLT Telemetry System for One-way Link DL3-05-12V RX10LTT-Link takes a 5-zone DigiLink transmitter and combines it with a RX10 receiver and two aerials to produce an off the shelf one-way radio link between fire or intruder panels. The transmitter has five input zones which can be triggered by volts-free opening or closing contacts or can be configured to accept voltage applied or voltage removed.The system is supplied pre-configured to operate change-of-state so a closing contact at the transmitter sends a signal to the receiver to activate the corresponding zone output relay. When the transmitter input is de-activated the relay is deactivated so the output actually follows the input. A programming kit is available if you need to reconfigure the system. Additional transmitters and receivers can be added when needed.This can simply be achieved by installing Digilink transmitters and receivers adjacent to the fire or security panels where their relay contacts can be hard wired into the output inputs of the panel in order to provide wireless alarm signals between buildings. For roaming fire marshals and security personnel the serial output of the receiver can be connected to the Scope Connexions Range of paging transmitters in order to send pre-programmed text messages to pocket worn pagers.It is also possible to connect the printer output of analogue addressable panel to a serial port of the Connexions transmitter in order to transmit real time panel messages to the pagers thus saving valuable time by not having to view the message at the panel. The same format could also be deployed for access control plant monitoring lone worker and care home applications where staff has to be made aware of situations arising from automated or manual inputs.

GBP 793.26
1

C-Tec ZFP2LCA ZFP 2 Loop Panel 5A Cast - Large Cabinet

C-Tec ZFP2LCA ZFP 2 Loop Panel 5A Cast - Large Cabinet

C-Tec ZFP2LCA ZFP 2 Loop Panel 5A Cast - Large CabinetA feature-rich touchscreen-controlled addressable fire panelwith C-Tec CAST compatible loop drivers.Created with the input of some of the worlds leading fire alarm and life safety experts the ZFP is the powerful touchscreen controlled fire alarm panel that everyones been waiting for.Designed and built in the UK the panel can be configured to suit any application. From small one out all out systems to large multi-loop networked systems with sophisticated cause and effects the ZFP can handle them all with ease.Simply tap the option you require and away you go. Whether youre the responsible person on site the installer the commissioning engineer or the emergency services you can access the information you require quickly and easily - all at the touch of a virtual button.Creating a sophisticated fire alarm system for an airport hospital university tower block hotel football stadium or other large building is just a few steps up from establishing a simple one out all out system for a small factory unit.All this and full compliance with EN54 parts 2 and 4 means that the ZFP is rapidly becoming the fire panel of choice for the fire industry worldwide.Key FeaturesThird-party certified to EN54 parts 2 4 and 13Multiple off-the-shelf variants or build your own panelusing our ZFP selection chartsRapid loop learn flexible cause effects and powerfulsystem diagnosticsHi-integrity fault-tolerant RS485 networking option allowsup to 128 network nodes 64 main panels and 64 Compact ControllersOptional A-Bus expansion PCBs paging and graphicinterface facilitiesENVISION Enabled fullly compatible with C-TECs new Cloudbased data managementremote access softwareIntuitive PC programming toolsLarge cabinetPlease note The image is for illustrative purposes only.

GBP 1758.59
1

Scope TLINKAC Telemetry System for One-way Link DL3-05-AC amp RX10SAC

Scope TLINKAC Telemetry System for One-way Link DL3-05-AC amp RX10SAC

Scope TLINKAC Telemetry System for One-way Link DL3-05-AC RX10SACT-Link takes a 5-zone DigiLink transmitter and combines it with a RX10 receiver and two aerials to produce an off the shelf one-way radio link between fire or intruder panels. The transmitter has five input zones which can be triggered by volts-free opening or closing contacts or can be configured to accept voltage applied or voltage removed.The system is supplied pre-configured to operate change-of-state so a closing contact at the transmitter sends a signal to the receiver to activate the corresponding zone output relay. When the transmitter input is de-activated the relay is deactivated so the output actually follows the input. A programming kit is available if you need to reconfigure the system. Additional transmitters and receivers can be added when needed.This can simply be achieved by installing Digilink transmitters and receivers adjacent to the fire or security panels where their relay contacts can be hard wired into the output inputs of the panel in order to provide wireless alarm signals between buildings. For roaming fire marshals and security personnel the serial output of the receiver can be connected to the Scope Connexions Range of paging transmitters in order to send pre-programmed text messages to pocket worn pagers.It is also possible to connect the printer output of analogue addressable panel to a serial port of the Connexions transmitter in order to transmit real time panel messages to the pagers thus saving valuable time by not having to view the message at the panel. The same format could also be deployed for access control plant monitoring lone worker and care home applications where staff has to be made aware of situations arising from automated or manual inputs.

GBP 1035.68
1